How to Break Down Polymers Using Light and Oxygen

Researchers discovered how to break down polymers effectively, without using high temperatures or pressures.

The researchers from The University of Akron used only ultraviolet light, oxygen, and a manganese-based catalyst, with no high temperatures or pressures involved. Specifically, they demonstrated how to break down polymers by converting unsaturated polybutadiene (PB), polydicyclopentadiene (PDCPD), and dehydrogenated high-density polyethylene (DH-HDPE) into functional products.

You can also read: New Recycling Technology Creates Plastics Soap

Plastics’ Stability Makes Them Difficult to Break Down

Plastics are a relatively recent innovation of humankind, but their mass production results in huge amounts of waste. Of course, they are used because of their stability and durability, but these properties also make them difficult to break down and recycle. For instance, as of 2017, manufacturers produced an estimated 8.3 billion metric tons of polymers. However, humans have only recycled 600 million metric tons of that. Given that, increasing the recycling of plastic waste is paramount to solving our daunting plastic pollution problem.

Recyclers Know How to Break Down Polymers Through Oxidation

Polymers are broken down naturally due to environmental oxidation, but that process is too slow for effective recycling. As a result, recyclers use quicker methods, such as oxidative cleaving, to break down polymers for recycling or upcycling. However, they are currently too costly, not environmentally friendly, and difficult to scale up for more widespread use.

The researchers focused on unsaturated polymers, which contain carbon atoms bonded to fewer than four other atoms. In this instance, the carbon atoms form carbon-carbon double bonds, or triple bonds depending on the other atoms present.

Using a Catalyst Made from an Abundant Metal

Manganese is one of the most abundant metals on Earth, and the researchers used its manganese triflate form, Mn(dtbpy)₂(OTf)₂, as a catalyst in this procedure. In order to do this, they combined it with methanol and dichloromethane, and they mixed in powder polymer samples to test for degradation rates. While they experimented with various conditions, the best outcomes for this study were at room temperature and 1 atm O₂, using a 365 nm photoreactor.

High Conversion Rates for Breaking Down Polymers

The researchers achieved higher than 70% conversion for PB, a linear polymer. Meanwhile, they converted harder-to-degrade crosslinked polymers PDCPD and DH-HDPE at 33% and 36% rates, respectively. In fact, their results showed functional conversion to acetal, aldehyde, ester, and epoxide, with acetal as the primary component. Importantly, acetal is extremely useful for polymer production, proving the recyclability of the original polymers with this method.

Without high temperatures or pressures, and with a more environmentally friendly method, recycling polymers is now easier than ever. Consequently, the researchers just showed how to break down polymers for a more sustainable polymer industry.

Read the full academic article here: Deconstruction of unsaturated polymers through photo-mediated oxidation under O₂ | Cell Reports Physical Science